P0456: EVAP System Very Small Leak Detected

P0456 is a powertrain diagnostic trouble code in the auxiliary emission controls group. Our vehicle database stores it against 41 models.

Low — monitor and plan11 recorded causes

What P0456 actually means

P0456 is one of the most widely logged codes in our database — 41 models record it. It is a powertrain code in the auxiliary emission controls group, and it is a generic code defined by SAE J2012 and shared by every manufacturer.

The stored definition for P0456 is “EVAP System Very Small Leak Detected”. The first character of the code identifies the system — Powertrain in this case. The second character tells you who defined the code: this one is a generic code defined by SAE J2012 and shared by every manufacturer. Reading the code that way matters: a generic code tests the same underlying condition on almost every vehicle, so the causes below apply broadly across makes.

Within that system, P0456 sits in the auxiliary emission controls group. That is the part of the vehicle the control module was watching when it set the code — the emissions hardware downstream of combustion — catalytic converter, evaporative system, and their sensors — and it narrows down enormously where a technician will start looking. Most of these are confirmed with a smoke test on the evap side or an oxygen-storage reading on the catalyst side.

What makes P0456 easy to get wrong. P0456 is the smallest leak the evaporative system can report, and the cause is usually mundane: a loose or cracked gas cap, or a degraded seal on one of the vapour hoses. Because the leak is so small, locating it needs a smoke machine rather than a visual inspection.

How serious is P0456?

We rate P0456 as Low — monitor and plan, the lowest of our three levels. That rating comes from the severity recorded in our database for this code, not from how alarming the name sounds.

A low-severity code rarely affects drivability in the short term and is often emissions- or efficiency-related. Many drivers continue normal use while scheduling diagnosis. The risk is that a low-severity code is sometimes the early signal of a component that fails more expensively later, so it should still be investigated rather than permanently ignored.

Most likely causes of P0456, ranked

Our database records 11 causes for P0456, ranked by how many of the 41 models that log this code report each one. A cause that shows up across many different platforms is a more probable starting point than one tied to a single model.

  1. Loose — the most widely recorded cause, appearing on 27 of the 41 models.
  2. cracked EVAP line — the most widely recorded cause, appearing on 26 of the 41 models.
  3. faulty fuel cap — the most widely recorded cause, appearing on 26 of the 41 models.
  4. Leaking EVAP purge valve — recorded on 10 of the 41 models logging P0456.
  5. Loose gas cap — recorded on 3 of the 41 models logging P0456.

6 further causes are recorded in the database for P0456; the full list is available in the cross-reference.

Causes are listed as recorded in the database. The same code can have different root causes on different vehicles, so the ranking is a starting order for diagnosis rather than a diagnosis in itself.

How a technician diagnoses P0456

Diagnosis for P0456 follows the same logic as any stored powertrain code: confirm the code is active rather than historic, then work through the ranked causes from cheapest and most likely to most intrusive. In practice that means:

How a technician works P0456 — decision path

Powertrain codes respond to data. Capture the freeze frame, then work through the ranked causes from cheapest and most likely to most intrusive.

  1. Confirm the code is active and capture freeze-frame dataThe snapshot recorded when the code set holds the engine speed, load, coolant temperature and fuel trims at that moment — often the single most useful piece of evidence for separating one candidate cause from another.
  2. Compare live data against the freeze frameRe-create the conditions from the snapshot and watch the relevant sensors live. A value that cannot reach the expected range narrows the search immediately.
  3. Work the ranked causes from cheapest and most likelyThe list on this page is ordered by how many of the recorded vehicles show each cause. Start at the top: an intake leak, a dirty sensor or a worn cap is far more common than a failed assembly.
  4. Repair the confirmed cause, then re-check the monitorsFix what the evidence actually points at rather than replacing parts speculatively — a misfire or lean code will re-set if the real cause is still present.
  5. Clear the code and complete a full drive cycleClearing alone proves nothing. The code must stay clear through a drive cycle that reproduces the original conditions, and the readiness monitors must run again.

If a workshop replaces a component for P0456 without showing you the measurement that condemned it, ask for the data. On a auxiliary emission controls code, the recorded causes are usually testable, so a diagnosis should be demonstrable rather than asserted.

What drives the cost of fixing P0456

We deliberately do not print a single repair price for P0456. Emissions hardware ranges from an inexpensive gas cap to a catalytic converter, one of the pricier single parts on a car. The honest answer is that the cost is set by which cause is actually present, and that range is wide — a repair for the first cause listed above and the last can differ by more than an order of magnitude in parts alone: a gas cap and a catalytic converter are not the same job. Add regional labour rates and the spread becomes wider still.

The factors that actually move the number, in rough order of impact:

  • The spread is the widest on the site. A gas cap sits at one end of this group and a catalytic converter at the other — the confirmed cause matters more than any other variable.
  • Smoke-test time. Finding an EVAP leak is labour rather than parts, and the time it takes is not predictable from the code.
  • Aftermarket versus OEM catalyst. The gap between the two is largest exactly here, and it is the decision most likely to change the final bill.
  • The underlying cause. Whether the leak or misfire that drove the system out of specification is fixed at the same time decides whether the code returns.

The practical approach: get the cause confirmed first, then collect two or three written quotes for that specific repair. To judge whether the repair is worth doing against the value of the vehicle, use our repair-or-replace decision guide.

Vehicles in our database that log P0456

This is one of the most widely logged codes in our database — 41 models record it. The makes appearing most often are BMW (9), Toyota (6), Honda (5), Subaru (5), Harley-Davidson (2). Each model links to its own guide, where this code appears alongside that vehicle's full fault list and running costs.

Frequently asked questions about P0456

What does the P0456 code mean?

P0456 is a powertrain trouble code meaning "EVAP System Very Small Leak Detected". It belongs to the auxiliary emission controls group of the SAE J2012 numbering scheme, and it is a generic code defined by SAE J2012 and shared by every manufacturer. The code is set by the powertrain control module when the monitored system reports a value outside its expected range.

Is it safe to drive with P0456?

Severity for P0456 is rated low in our database. A low-severity code rarely affects drivability in the short term and is often emissions- or efficiency-related. Many drivers continue normal use while scheduling diagnosis. The risk is that a low-severity code is sometimes the early signal of a component that fails more expensively later, so it should still be investigated rather than permanently ignored.

What are the most common causes of P0456?

In our vehicle database, the causes recorded for P0456 are: Loose; cracked EVAP line; faulty fuel cap; Leaking EVAP purge valve; Loose gas cap; cracked EVAP hose; cracked hose; EVAP hose; faulty gas cap; Fuel cap; purge valve leak. They are ranked on the page by how many of the 41 vehicles that log this code list each cause.

How much does it cost to fix P0456?

We do not publish a single figure for P0456 because the real cost depends entirely on which cause is present — a repair for the cheapest cause on the list and the most expensive one differ by an order of magnitude, and labour rates vary by region. The page explains which factors drive the cost and recommends collecting written quotes before authorising work.

Which vehicles commonly report P0456?

Our database stores P0456 against 41 vehicles, most frequently from BMW (9), Toyota (6), Honda (5), Subaru (5), Harley-Davidson (2). The full list is shown on this page and each model links to its own cost and fault guide.

Related codes and next steps

Codes that share the same system group often appear together, because a single fault can set more than one:

For the full list, see the OBD-II fault code cross-reference. If the repair cost is what you are weighing, model the total with our total cost of ownership calculator before deciding, and check whether an open safety recall covers the fault with the recall lookup.

Sources and scope

Code definitions follow SAE J2012 / ISO 15031-6 naming. The descriptions, listed causes, and severity ratings on this page are the values stored in the VehCalc vehicle database (snapshot 2026-08-20) for the models listed above. Codes and causes vary by model year and engine.

Diagnostic reference only — not repair advice. This page is provided for educational and planning purposes and does not replace an inspection by a qualified technician or the manufacturer's service information. Before repairing a vehicle you depend on, confirm the diagnosis with an ASE-certified mechanic.

Related tools from our network

A focused set of free calculators and guides across related topics — no account required.