P0442: EVAP System Leak Detected (Medium)

What P0442 actually means

The stored definition for P0442 is “EVAP System Leak Detected (Medium)”. The first character of the code identifies the system — Powertrain in this case. The second character tells you who defined the code: this one is a generic code defined by SAE J2012 and shared by every manufacturer. Reading the code this way matters, because it tells you whether the fault is a generic behaviour common to most vehicles or something a specific manufacturer chose to monitor.

Within that system, P0442 sits in the auxiliary emission controls group. That is the part of the powertrain the control module was monitoring when it set the code, and it narrows down enormously where a technician will start looking.

How serious is P0442?

We rate P0442 as Low — monitor and plan. That rating comes from the severity recorded in our database for this code, not from how alarming the name sounds.

A low-severity code rarely affects drivability in the short term and is often emissions- or efficiency-related. Many drivers continue normal use while scheduling diagnosis. The risk is that a low-severity code is sometimes the early signal of a component that fails more expensively later, so it should still be investigated rather than permanently ignored.

Most likely causes of P0442, ranked

These causes are taken from the vehicles in our database that log this code, ranked by how many of them record each cause. A cause that shows up across many different platforms is a more probable starting point than one tied to a single model.

1. Purge valve — recorded for 3 of the 5 vehicles logging P0442.
2. Loose gas cap — recorded for 2 of the 5 vehicles logging P0442.
3. cracked EVAP canister hose — recorded for 1 of the 5 vehicles logging P0442.
4. cracked EVAP purge valve — recorded for 1 of the 5 vehicles logging P0442.
5. gas cap — recorded for 1 of the 5 vehicles logging P0442.
6. gas cap seal — recorded for 1 of the 5 vehicles logging P0442.
7. gas cap seal failure — recorded for 1 of the 5 vehicles logging P0442.

Causes are listed as recorded in the database. The same code can have different root causes on different engines, so the ranking is a starting order for diagnosis rather than a diagnosis in itself.

How a technician diagnoses P0442

Diagnosis for P0442 follows the same logic as any stored code: confirm the code is active rather than historic, then work through the ranked causes from cheapest and most likely to most intrusive. In practice that means:

1. Re-read the codes and capture freeze-frame data. The snapshot taken when P0442 was set records the engine conditions at that moment, which is often what separates one candidate cause from another.
2. Check for the cheap, physical causes first. Several of the causes recorded for this code — purge valve, loose gas cap, cracked evap canister hose — can be inspected visually or with a basic tool before any part is replaced.
3. Test rather than guess. A technician should confirm the faulty component with live data or a measurement before replacement. Parts-swapping on a powertrain code is the single most common reason a repair costs more than it needed to.
4. Clear the code and verify the fix. Clearing alone proves nothing; the code must stay clear through a full drive cycle that reproduces the original conditions.

If a workshop replaces a component for P0442 without showing you the measurement that condemned it, ask for the data. On this code family, the recorded causes are usually testable, so a diagnosis should be demonstrable rather than asserted.

What drives the cost of fixing P0442

We deliberately do not print a single repair price for P0442. The honest answer is that the cost is set by which cause is actually present, and that range is wide — a repair for the first item in the ranked list above and the last can differ by more than an order of magnitude in parts alone. Add regional labour rates and the spread becomes wider still.

The factors that actually move the number, in rough order of impact:

• Which candidate cause is confirmed. A cleaning or adjustment is a different job from replacing a major assembly.
• Access. Components buried against the firewall or under the intake can add hours of labour that have nothing to do with the part price.
• OEM versus aftermarket parts. The gap is largest on emissions and sensor components.
• Whether diagnosis is billed separately and whether it is credited against the repair.

The practical approach: get the cause confirmed first, then collect two or three written quotes for that specific repair. To judge whether the repair is worth doing against the value of the vehicle, use our repair-or-replace decision guide.

Vehicles in our database that log P0442

5 models store this code. The makes appearing most often are Ford (2), Acura (1), Chevrolet (1), Honda (1). Each model links to its own guide, where this code appears alongside that vehicle's full fault list and running costs.

Frequently asked questions about P0442

Related codes and next steps

Codes that share the same system group often appear together, because a single fault can set more than one:

For the full list, see the OBD-II fault code cross-reference. If the repair cost is what you are weighing, model the total with our total cost of ownership calculator before deciding, and check whether an open safety recall covers the fault with the recall lookup.